Minebea Intec PR 5230 - Print Parameters

Save the data with [Yes].
Press [No] to exit the menu without changing data.
7.15.4 Print parameters
Note:
This menu item is only available if under -[Operating parameter]- [Application]
"Standard" has been selected.
The print parameters are set under this menu item.
Open the menu via -[Printing parameter].
[Printing mode]
Printing mode
Selection: <Triggered> trigger one printout, Cyclic, Cyclic with enable
[Printing interval]
Printing interval
This menu item only appears if the [Cyclic] or [Cyclic with enable] printing mode has been
selected.
Input: 1250
[Printing interval unit]
Unit of the printing interval
Selection: Seconds, Minutes, Hours, Meas. time
Transmitter in eld housing PR 5230 7 Commissioning
Minebea Intec EN-188