Minebea Intec PR 5230 - Selecting and Configuring RS-485 Interface

The calibration data for the gravity acceleration at the place of installation can be adapted
only in the instrument and protected against overwriting (see Chapter 7.1.3.1).
With legal-for-trade applications, the legal requirements and the conditions given on the
test/approval certicate must be taken into account when selecting the settings.
For connecting digital load cells (xBPI load cells), rmware version 3.10 or higher must be
installed.
The available interfaces are visible under -[Show HW-slots].
7.14.2 Selecting and conguring RS-485 interface
1. Select -[Serial ports parameter]- [xBPI-Port] and conrm.
The following window opens:
2. Select the desired interface and conrm.
3. Press the [Param] softkey.
The following window opens:
7 Commissioning Transmitter in eld housing PR 5230
EN-163 Minebea Intec