14 Repairs and maintenance
14.1 Repairs
Repairs are subject to inspection and must be carried out at Minebea Intec.
In case of defect or malfunction, please contact your local Minebea Intec dealer or service
center for repair.
When returning the device for repair, please include a precise and complete description of
the problem.
14.1.1 Battery for date/time
The lithium battery (1) for back-up of the calendar/time chip is located beside the power
supply on the main board.
The battery is activated before the instrument leaves the factory.
Note:
After initial start-up, the clock must be checked and set, if necessary, under -
[Date&Time].
14.1.2 Changing the battery for date/time
The instrument is equipped with a lithium battery for back-up of the time/calendar chip.
If the voltage drops below the specied minimum, or in case of defect, the battery must
be replaced by Minebea Intec customer service or by an equivalent trained technician.
The battery is activated by setting the date and time under - [Date&Time].
For disposal information, see Chapter 15.
For battery lifespan, see Chapter 17.3.1.
14.2 Maintenance
Maintenance work may only be carried out by a trained technician with expert knowledge
of the hazards involved and the required precautions.
14 Repairs and maintenance Transmitter in eld housing PR 5230
EN-283 Minebea Intec
To Next Page
Loading...
