Minebea Intec PR 5230 - Updating New Software with Flashit

Press [No] if you want to keep the entered values unchanged.
9.1.5 Updating new software with FlashIt
Note:
Always ash/load the BIOS into the device rst, and then the rmware&application.
9.1.5.1 Updating in network with a DHCP service
Requirements:
- Device and Notebook/PC are connected to the network.
- The automatic address assignment "DHCP" is activated in the device and in the
notebook/PC, see Chapter 7.15.6.
- The "FlashIt!32" program (in a directory on the enclosed CD-ROM) is installed on the
notebook/PC.
- The "FlashIt!32" program is started.
3. Press the [Yes] softkey to reset to the factory settings.
The following messages show the respective progress:
Transmitter in eld housing PR 5230 9 Extended functions
Minebea Intec EN-246