Minebea Intec PR 5230 - Parameter Input

Unless all data were determined during recalibration using [New] (e.g. dead load not set/
entered), the following prompt is displayed:
7.14.12 Parameter Input
The menu is accessible via - [Weighing point] - [Weighing point A] - [Assign] - [Calib]
- [Param] .
1. Press the [Yes] softkey to exit the calibration.
2. Conrm .
A prompt window opens.
3. Press the [Save] softkey to save changes in calibration data.
The verication is displayed by "Saving calibration".
4. Press the [Undo] softkey if you do not want to save the changes.
Leaving the menu is displayed by "Exit calibration".
The scale returns to the selection menu.
5. After nishing calibration, set the CAL switch to the closed position; see
Chapter 7.1.3.1.
7 Commissioning Transmitter in eld housing PR 5230
EN-173 Minebea Intec