Minebea Intec PR 5230 - Network Parameters

Card test:
The device display shows the eldbus card status.
Under - [HW-Slots] - [Slot 2] all inputs and outputs are displayed.
Procedure:
Note:
Further details can be found in the supplementary application manual "How to"
(available upon request from technical.support.hh@minebea-intec.com).
Note:
See Chapter "Description of the I/O Area"
Example:
The gross weight should be read.
I/O size = 8 bytes, counted from byte 0–7
7.15.6 Network parameters
Under this menu item, you can dene the network parameters for the network
connections (built-in LAN adapter).
Open the menu via - [Network parameter].
[HW address]
This parameter cannot be changed because the xed address is specied by the
instrument.
1. Enter the IP address and network mask under - [Fieldbus parameter] and
conrm.
2. Register the le "sag_5230_Ethernetip.eds" using the "Hardware Installation Tool".
3. Select and insert the instrument from the catalog into the I/O conguration.
7 Commissioning Transmitter in eld housing PR 5230
EN-193 Minebea Intec