Description Data
Cable length <150 m screened
Accessories Fixing screw M3×12,
Spacer ring 3 mm thick
Analog signal "Current output" Analog signal "Voltage output"
Current is supplied directly via the terminals. The voltage level corresponds to the drop across the
external 500 Ω resistor.
4.6.3 Load cell junction board
The load cell junction board has the type designation PR 5230/22. The board is connected
to the weighing electronics board by a ribbon cable and is plugged into "slot 3" (see
Chapter 4.6.1).
4 Device installation Transmitter in eld housing PR 5230
EN-77 Minebea Intec
To Next Page
Loading...
