Minebea Intec PR 5230 - Cancelling a Calibration

You are prompted to conrm whether calibration should be closed without determining
the test value.
By pressing [Save] altered calibration data are saved.
The verication is displayed by "Saving calibration".
Leaving the menu is displayed by "Exit calibration".
After nishing the calibration, set the CAL switch to the closed position; see also Chapter
7.1.3.1.
7.12.14 Cancelling a calibration
Quit calibration by pressing the softkey.
You are prompted to conrm whether calibration should be closed without determining
the test value.
Transmitter in eld housing PR 5230 7 Commissioning
Minebea Intec EN-140