Minebea Intec PR 5230 - Analog Outputs

- "Slot 1": PR 5230/06 analog output board (see Chapter 4.6.2)
- "Slot 2": PR 1721/4x (eldbus card)
- "Slot 3": PR 5230/22 load cell junction board (see Chapter 4.6.3)
WARNING
Working on the device while it is switched on may have life-threatening
consequences.
Before installing or removing a plug-in card, the device must be disconnected from
all voltage sources.
Note:
After installation/modication, the plug-in cards are detected automatically.
The installed plug-in cards, except for PR 5230/22, can be displayed via - [Show
HW-Slots]; see Chapter 7.16.3.
4.6.2 Analog outputs
The analog output board has the type designation PR 5230/06. It has a 2-pole screw
terminal for an active analog output. The card is inserted into "slot 1" (see Chapter 4.6.1).
4 Device installation Transmitter in eld housing PR 5230
EN-75 Minebea Intec