Minebea Intec PR 5230 - 14.2 Maintenance

Specications
Description Data
Connection Terminal, 4× 4-pin
Number of load cells
14
Load cell type Strain gauge, 6 or 4-wire connection possible
4.6.4 Status LEDs on eldbus card
Watchdog LED
Frequency Color Meaning
Flashing 1 Hz green Module is initialized and ready for operation.
Flashing 2 Hz green Module is not initialized.
Flashing 1 Hz red Check error in ASIC and FLASH ROM: Module is
defective.
4.6.5 ProBus-DP interface
The ProBus-DP interface card has the type designation PR 1721/41.
Communication protocols and syntax comply with the ProBus-DP standard to IEC 61158,
with transfer rates up to 12 Mbit/s.
Connection to the ProBus is established using the 6-pole terminal in the device.
The card is inserted into "Slot 2"  (see Chapter 4.6.1).
Transmitter in eld housing PR 5230 4 Device installation
Minebea Intec EN-78