Minebea Intec PR 5230 - Selecting the Calibration Mode

7.12.3 Selecting the calibration mode
Note:
The [Modify] menu item is only used for small changes (e.g.changing the dead load/
preload, changing the mV/V values for dead load/preload and/or Max, changing the
scale interval). Otherwise select the [New] menu item.
Under -[Weighing point]- [Calib] choose between [New] and [Modify].
7.12.3.1 Performing a new calibration
1. Select -[Weighing point]- [Calib] and conrm.
2. Press the [New] softkey.
A prompt window opens.
Transmitter in eld housing PR 5230 7 Commissioning
Minebea Intec EN-126