Minebea Intec PR 5230 - Restart; Switching on the Device

7.1.4 Restart
The instrument can be reset using a round-headed pin with a diameter of approx. 2.0
mm.
After pressing the Reset key (1) briey (less than 1 sec.), the device is restarted.
Restarting has the following eects on the device:
- Current process steps are deleted.
- The device is reset to its factory settings.
- The network settings are not changed.
7.2 Switching on the device
The device can be set up as follows:
- Via a notebook/PC using the VNC software (included on the CD)
- Via a notebook/PC using an Internet browser
As soon as the device is provided with power, the display and/or Notebook/PC shows:
Checking…
Booting…
Restoring…
The device is booting up.
PR 5230 - Message with device type PR 5230
- BIOS version
- Firmware version
- Automatic display test
- Weight display
E:NoSig Error message: no load cells are connected; see also
Chapter 16.1.
Transmitter in eld housing PR 5230 7 Commissioning
Minebea Intec EN-108