Minebea Intec PR 5230 - Functions Via the WEB Site

Input: 0 and 1 (e.g.: 111; 001)
An info window is shown briey.
Input: 0 and 1 (e.g.: 111; 100)
9.1.3 Functions via the WEB site
9.1.3.1 General information
If the device is connected to the network, it can be displayed e.g.in the "Windows"
operating system under "Network".
2. Press the [Stop i/o] softkey.
3. Enter the input values using the keyboard and conrm.
The inputs are simulated to test the functionality of the PLC (application); see
Chapter 9.1.2.
An info window is shown briey. The "Internal" test mode is active.
4. Press to return to the previous window.
5. Press the [Stop PLC] softkey.
6. Enter the output values using the keyboard and conrm.
The physical inputs and outputs (hardware) are tested without the involvement of
the PLC (application) (see Chapter 9.1.2).
An info window is shown briey. The "External" test mode is active.
7. Press to return to the previous window.
Transmitter in eld housing PR 5230 9 Extended functions
Minebea Intec EN-234