Minebea Intec PR 5230 - Page 153

[Tare timeout]
Timeout for a zeroset or tare command to be executed.
If the xBPI scale has not executed the command in the specied time, the action will
be aborted.
Setting range: 09.9 s
[Serial number]
Serial number of the connected xBPI scale/weighing module.
The number is required for checking when used in legal metrology.
With serial number "0", checking is omitted.
Setting range: 099999999
[SBN Address]
When the address is not set to 0, bus operation is active. Possible addresses: 1–31,
i.e., max. 31 xBPI scales can be operated on an RS-485 branch.
The SBN Address is shown on the display.
Example: Address 31 at WP-A
2. Press the [Cong] softkey.
3. Enter the following parameters.
Transmitter in eld housing PR 5230 7 Commissioning
Minebea Intec EN-150