Minebea Intec PR 5230 - Page 160

1. Select -[Weighing point]- [xBPI-Scale] and conrm.
2. Press the [Setup] softkey.
Ticks indicate the progress.
An error message is displayed if communication with the xBPI scale is not
possible!
The following window opens:
The parameters of the xBPI-scale are read into the device.
3. Select [Calibration] with the cursor and conrm.
The following window opens:
7 Commissioning Transmitter in eld housing PR 5230
EN-157 Minebea Intec