Minebea Intec PR 5230 - Page 55

Conguration
PR 5230-1 PR 5230-2 PR 5230-3 PR 5110
- [Serial ports para-
meter]- [Remote display]-
[Builtin RS485]
[Param][Mode multiple
transmitters]
[Param] - [Device Id A]
[Param] - [Next Device
Id B]
- [Serial ports para-
meter]- [Remote display]-
[Builtin RS485]
[Param][Mode multiple
transmitters]
[Param] - [Device Id B]
[Param] - [Next Device
Id C]
- [Serial ports para-
meter]- [Remote display]-
[Builtin RS485]
[Param][Mode multiple
transmitters]
[Param] - [Device Id C]
[Param] - [Next Device
Id A]
[ ]- [oP 10]- [LInE]-
[rS485]
[ ]- [oP 12]- [tokEn]-
[ActIvE]
[ ]- [oP 13]- [SEnd-
ModE]- [SEnd]
[ ]- [oP 14]- [WEIght]-
[FolloW]
[ ]- [oP 15]- [WPkEy]-
[SElEct]
4.4.6.7 Connecting several PR 5110 remote displays
Multiple PR 5110 remote displays can be connected via the RS-485 interface.
Four-wire transmission and full duplex (simultaneous sending and receiving possible) is
possible.
Transmitter in eld housing PR 5230 4 Device installation
Minebea Intec EN-52