Minebea Intec PR 5230 - 7.15.10 Configuring digital outputs

Conguration
PR 5230 PR 5110-1 PR 5110-2 PR 5110-3
- [Serial ports para-
meter]- [Remote display]-
[Builtin RS485]
[Param]- [Mode]- [single
transmitter]
[ ]- [oP 10]- [LInE]-
[rS485]
[ ]- [oP 12]- [tokEn]-
[oFF]
[ ]- [oP 13]- [SEnd-
ModE]- [SEnd]
[ ]- [oP 14]- [WEIght]-
[FolloW]
[ ]- [oP 15]- [WPkEy]-
[SElEct]
[ ]- [oP 10]- [LInE]-
[rS485]
[ ]- [oP 12]- [tokEn]-
[oFF]
[ ]- [oP 13]- [SEnd-
ModE]- [SEnd]
[ ]- [oP 14]- [WEIght]-
[FolloW]
[ ]- [oP 15]- [WPkEy]-
[SElEct]
[ ]- [oP 10]- [LInE]-
[rS485]
[ ]- [oP 12]- [tokEn]-
[oFF]
[ ]- [oP 13]- [SEnd-
ModE]- [SEnd]
[ ]- [oP 14]- [WEIght]-
[FolloW]
[ ]- [oP 15]- [WPkEy]-
[SElEct]
4.4.6.8 Connecting an IS platform
One IS platform with xBPI or SBI protocol can be connected via the RS-485 interface
(2-wire).
Switch settings PR 5230 Conguration PR 5230
ON: S1, S2, S3, S4, S5, S7
OFF: S1, S6, S8
- [Serial ports parameter]- [xBPI-Port]- [Builtin RS-485]
Transmitter in eld housing PR 5230 4 Device installation
Minebea Intec EN-54