Mitel 6940 - Using the Paging Key; Discreet Ringing Key; Configuring a Discreet Ringing Key

Configuring Softkeys
cxxxiii
10. To receive RTP steams for group paging, you must also configure the Paging Listen Addresses
parameter at the path,
Basic Settings > Preferences > Group Paging RTP Settings . For more
information about setting this parameter, see “Group RTP Paging” on page ccxvi.
11. Click Save Settings to save your changes
Using the Paging Key
The following procedure describes the use of the Paging key on the IP phone. The procedure
assumes you have already configured the
Paging key using the Mitel Web UI.
1. On the IP phone, press the softkey or expansion module key you configured for Paging .
The phone opens a multicast RTP session and an outgoing OR incoming phone screen displays.
2. Press the Drop key to end the multicast RTP session and return to the Home screen.
Discreet Ringing Key
You can configure a Discreet Ringing key on the phone that when pressed allows you to toggle
on/off the Discreet Ringing feature. When the Discreet Ringing feature is enabled, if a call is incoming,
the phone will play the configured ring tone once only. All applicable visual indicators (LED for the
corresponding Line key, Message Waiting Indicator [MWI], etc...) will behave normally.
Configuring a Discreet Ringing Key
1. Click on Operation > Softkeys and XML .
or
Click on
Operation > Expansion Module <N> .
Notes:
1.
The recipient of a paging call can set a global DND to ignore any incoming pages.
2. For incoming paging, the phone uses the Intercom configuration settings. The
incoming page is dependent on the
Allow Barge In parameter setting and the
idling/on call state.
Note: If you enable global DND on the phone, the incoming multicast RTP session is
dropped.
Note: If a custom ring tone is selected and Discreet Ringing is enabled, the phone will
not play the custom ring tone during an incoming call. Ring tone 1 will be played once
instead.