Mitel 6940 - Configuring Preferred Line and Preferred Line Timeout

Mitel 6940 SIP Phone User Guide
ccxii
Configuring Preferred Line and Preferred Line Timeout
1. Click on Basic Settings > Preferences > General .
Transfer For incoming or outgoing calls, the current behavior is that the same line
used to transfer the call does not change. For incoming calls, the phone
switches back immediately after the call transfers.
Park The phone switches back immediately after the call ends.
Voicemail The phone switches back immediately after the call ends.
Outgoing Redial The phone switches back immediately after the call ends.
Dialing For incomplete dialing on a non-preferred line, the focus does not change if
some digits are entered.
If no digits are entered or digits were cleared, the focus changes to preferred
line after the time out has passed without activities.
Caller ID If the Switch UI Focus To Ringing Line parameter is disabled, the User is
able to see the Caller ID when the phone switches the focus to the ringing
line.
Factory Default Factory default and recovery mode clears the preferred line and preferred
line timeout parameters, and the phone operates in a non-preferred line
mode.
Notes:
1.
If you specify a value of 0 for the Preferred Line parameter, it disables the preferred
line focus feature.
2. If you specify a value of 0 for the Preferred Line Timeout parameter, the phone
returns the line to the preferred line immediately.
Phone Feature Preferred Line Behavior