Mitel 6940 - Page 189

Managing Calls
clxxxix
Configuring Call Forward Using the Mitel Web UI
1. Click on Basic Settings > Preferences > General .
2. In the Call Forward Key Mode field, select a call forward mode to use on the phone.
• Account (default): The Account mode allows you to configure Call Forward on a per account
basis. Pressing a configured
Call Forward key applies to the account in focus.
• Phone: The Phone mode allows you to set the same Call Forward configuration for all
accounts (All, Busy, and/or No Answer). When you configure the initial account, the phone
applies the configuration to all other accounts. (In the Mitel Web UI, only the account you
configured is enabled. All other accounts are greyed out but set to the same configuration.)
Using the Mitel Web UI, if you make changes to that initial account, the changes apply to
all accounts on the phone.
• Custom: The Custom mode allows you to configure Call Forward for a specific account or
all accounts. You can configure a specific state (All, Busy, and/or No Answer) for each
account independently or all accounts. On the 6940, you can set all accounts to
All On , All
Off
, or copy the configuration for the account in focus to all other accounts using a CopytoAll
softkey.
3. Click Save Settings .
The changes takes affect immediately without a reboot.
Note: If there is only one account configured on the phone, then the mode setting
is ignored and the phone behaves as if the mode was set to Phone.