Entering Usernames/Passwords and Connection Testing Using the IP Phone UI
1.
Press on the phone to enter the Options List.
2.
Press the
Credentials
icon.
3.
Press the left and right arrow buttons on the feature tab to navigate to the desired feature (e.g.
LDAP, Microsoft Exchange).
4.
Press the
Username
field and enter in the username applicable to the Directory source.
5.
Press the
Password
field and enter in the password applicable to the Directory source.
6.
Repeat Steps 3 to 5 for any other features you want to configure.
7.
Press the right arrow button on the features tab until you reach the
Test Connection
tab.
8.
Press the checkboxes corresponding to the features you want to test to enable authentica-
tion/connection testing on the features.
9.
Press the
Test
softkey to begin testing.
A green
will appear if there are no issues with the authentication/connection to the external
source.
A red
!
will appear if issues are found.
If there are issues with your connection, please check your username and password for any
errors.
To Next Page
Loading...
