FRONT SUSPENSION – Lower Arm <EVOLUTION-V>
33A-7
LOWER ARM <EVOLUTION-V>
REMOVAL AND INSTALLATION
Caution
To prevent bushing from being galled, the part
marked with * should be first temporarily tightened,
then torqued to specification with the vehicle on
the ground in unloaded condition.
Post-installation Operation
(1) Push the Dust Cover of the Lower Arm and Stabilizer
Link Ball Joint with a Finger to Check for Possible
Cracks or Damage.
(2) Wheel Alignment Check and Adjustment
(Refer to P.33A-3.)
1
2
3
4
5
6
Unit: Nm {kgf@m}
Molybdenum disulfide-base chassis
grease:
SHOWA SHELL SEKIYU SUNLITE
MB2, NISSEKI CLAKNOCK FL, or
equivalent
39 {4.0}
108 {11.0}
137 {14.0}
88 {9.0}
106 {10.8}*
6
Removal steps
1. Stabilizer link mounting nut
AA""BA 2. Lower arm to knuckle coupling bolt
3. Bolt
4. Stabilizer bracket
"AA 5. Bushing assembly
6. Lower arm assembly
NOTE
Follow the conventional procedures for removal service
points.
To Next Page
Loading...
