Mold-Masters M2 - 6.21 Save tool settings; 6.21.1 Over-writing the last settings with new saved settings

OPERATION
© 2014 Mold-Masters (2007) Limited. All Rights Reserved.
Revised 1 Oct, 2014
6-30
www.moldmasters.com
6.21 Save tool settings
If you change tool settings and want to save them, then you have two
choices.
6.21.1 Over-writing the last settings with new saved
settings
If you know that the new settings are satisfactory, then you can save
them back into the same tool store.
1. Select the tool.
2. Choose [
Save] and [OK].