SAFETY INSTRUCTIONS
© 2014 Mold-Masters (2007) Limited. All Rights Reserved.
Revised 1 Oct, 2014
3-1
Section 3 - Safety Instructions
The M2-Series Controller is an electrical distribution and control de-
vice which is designed to be safe during normal operation.
It is essential that the user DOES NOT open the cabinet without rst
ISOLATING the mains supplies to the equipment - there may be termi-
nals inside the cabinet which may have a dangerous potential across
them.
Where a three-phase supply is used then this potential may be at 380
volts or higher.
3.1 Safety Notices - an explanation
A WARNING symbol and message, shown here, identies where
there may be a hazardous situation which, if not avoided, may result in
death or injury to personnel.
Most warnings pertain to electrical aspects and you must comply with
them to minimise any personal danger.
A CAUTION identies where there may be a hazardous situation
which, if not avoided, may result in damage to property.
Caution warnings present no personal danger, but may cause the
equipment to fail or lose its memory.
3.2 Where to use this equipment
The display console and controller cabinet together are designed for
use in the plastic injection moulding industry as temperature control-
lers for third party hot runner systems as commonly used in mold
tools. They must not be used in residential, commercial or light-indus-
trial environments. Furthermore, they must not be used in an explosive
atmosphere, or where there is a possibility of such an atmosphere
developing.
The HRC cabinet and Touch Screen console should be installed in a
clean dry environment where the ambient conditions do not exceed
the following limits:
• Temperature 0 to +35°C.
• Relative Humidity 90% (non-condensing)
CAUTION
To Next Page
Loading...
