OPERATION
© 2014 Mold-Masters (2007) Limited. All Rights Reserved.
Revised 1 Oct, 2014
6-1
Section 6 - Operation
This section of the manual is divided into several main areas that
include:
• the basic Starting and Stopping along with Boost and Pause con-
trols.
• changing temperature settings while the controller is running.
• inspecting historical graphs and event logs to trace back how the
controller has behaved over the last 5 or 30 minutes, or even the
last 24 hours.
• recognising what alarms may be generated, what they mean and
what to do about them.
• using the toolstore and other facilities to adapt quickly to different
circumstances.
What is included in this section
Logging in and out
Control Zones – Start, Stop and more
Use the Display Page to control and monitor temperatures
Use the Easy-View page to control and monitor temperatures
Use the Purge Option
Looking at temperature history for the last 5 to 30 minutes
Looking at temperature history for the last 24 hours
Check the log book for past events
Alarms - what alarms may be seen on the controller.
Using the ToolStore Page
Creating a new Tool
Renaming an Existing Tool
Loading Tool settings (Locally & Remotely)
Saving Tool settings
Deleting a Tool
Backing-up Tool Settings
Restoring tool settings
The Picture Page
The Quad I/O Card
To Next Page
Loading...
