Mold-Masters M2 - Default Chapter; Table of Contents

© 2014 Mold-Masters (2007) Limited. All Rights Reserved.
Revised 1 Oct, 2014
IV
www.moldmasters.com
Table of Contents
Section 1 - Introduction .......................................................1-1
1.1 INTENDED USE .......................................................................................................1-1
1.2 AUDIENCE ...............................................................................................................1-1
1.3 REQUIRED USER SKILLS ......................................................................................1-1
1.4 RELEASE DETAILS .................................................................................................1-1
Section 2 - Global Support ..................................................2-1
Section 3 - Safety Instructions ............................................3-1
3.1 SAFETY NOTICES - AN EXPLANATION .................................................................3-1
3.2 WHERE TO USE THIS EQUIPMENT .....................................................................3-1
3.2.1 MOLD HEATING ..............................................................................................3-1
Section 4 - Overview ............................................................4-1
4.1 SPECIFICATION ......................................................................................................4-1
4.2 HOW TO ISOLATE THE CONTROLLER .................................................................4-2
4.2.1 SWITCHING ON ..............................................................................................4-2
4.2.2 MOLD HEATING ..............................................................................................4-2
4.3 SWITCHING OFF (THE CONTROLLER) .................................................................4-3
4.4 SCREEN LAYOUT AND NAVIGATION ....................................................................4-4
4.5 MAIN PAGE ..............................................................................................................4-5
4.6 DISPLAY PAGE – OTHER SYMBOLS AND WHAT THEY MEAN ...........................4-6
4.7 DISPLAY PAGE – MONITORING (KTS SCREEN) ..................................................4-7
4.8 DISPLAY PAGE – MONITORING (TSA2 WIDE SCREEN) ......................................4-9
4.9 DISPLAY PAGE – AUTOMATIC RESIZING FOR FEWER ZONES .......................4-11
4.9.1 BIG PANELS ..................................................................................................4-11
4.9.2 MEDIUM PANELS .........................................................................................4-11
4.9.3 NORMAL PANELS .........................................................................................4-11
4.10 DISPLAY PAGE – MONITOR (ZOOM) .................................................................4-12
4.11 DISPLAY PAGE – START, STOP AND MORE .....................................................4-13
4.12 MAIN PAGE – HOW TO SET TEMPERATURE ...................................................4-14
4.13 MORE PAGES ......................................................................................................4-16
4.13.1 EASYVIEW ..................................................................................................4-16
4.13.2 GRAPH PAGE .............................................................................................4-16
4.13.3 THE TOOLSTORE PAGE ............................................................................4-16
4.13.4 THE PICTURE PAGE ..................................................................................4-17
4.13.5 THE UTILITIES PAGE .................................................................................4-17
4.13.6 THE TESTING PAGE ..................................................................................4-18
4.13.7 THE SETUP PAGE ......................................................................................4-18
4.14 USER INPUT ........................................................................................................4-19
Section 5 - Set Up .................................................................5-1
5.1 STAGES INCLUDED IN SETTING UP A CONSOLE ...............................................5-2
5.1.1 CREATE A FIRST TOOL .................................................................................5-2
5.1.2 SET UP TOOL PARAMETERS ........................................................................5-2
5.1.3 CONFIGURE SYSTEM SETTINGS ................................................................5-2
5.1.4 SET UP OPERATING PARAMETERS ............................................................5-2