Mold-Masters M2 - 6.8 Use EasyView to change temperatures

OPERATION
© 2014 Mold-Masters (2007) Limited. All Rights Reserved.
Revised 1 Oct, 2014
6-10
www.moldmasters.com
6.8 Use EasyView to change temperatures
1. Select the desired zones.
2. Choose [
Set] to display the keyboard.
3. And then:
a) To Set a new temperature, choose [
Set].
b) To Raise the overall temperature, choose [
Add].
c) To Lower the overall temperature, choose [
Subtract].
4. Enter the Temperature setting or change.
5. Choose [
Enter] to make the setting or [Esc] to defer the action.