SETUP
© 2014 Mold-Masters (2007) Limited. All Rights Reserved.
Revised 1 Oct, 2014
5-31
5.14 Passwords and User Access Explained
There are 12 levels of user access which are grouped into three fami-
lies.
Levels 1-4 - Operator Level
This low-level access is generally restricted to basic operations such
as Start and Stop, Load and Restore tools.
Levels 5-8 - Maintenance Level
This mid-level access gives Operator facilities and adds in further op-
erations such as Set Temperatures, Slave zones, change alarm levels,
change tool settings, congure the set-up page and inspect event log.
Levels 9-12 - Supervisor Level
This high-level access gives access to all functions in steps so that
only Level 12 has complete access to all functions.
Backing up your security settings
These twelve user levels share over 100 different functions. Even with
a factory default restore we would advise that whenever you make any
changes to the default option your next step should be to export those
settings to a USB memory stick. You may need to restore it at a later
date.
To Next Page
Loading...
