INTRODUCTION
© 2014 Mold-Masters (2007) Limited. All Rights Reserved.
Revised 1 Oct, 2014
1-1
1.1 Intended Use
This manual is intended for use with the M2-Series Controller together with
either the TS or KTS Console
It is written and prepared for Software Version – 14th January 2014
Mold-Masters Hot Runner Controllers such as this M2 series have been
designed as a multi channel temperature controller for use in Hot Runner
plastic molding equipment. They use feedback from thermocouples within the
nozzles and manifolds to give precise closed-loop temperature control.
Any other uses would fall outside the engineered intent of this machine which
may be a safety hazard and would void any and all warranties.
This manual is designed to cover most system common congurations. If you
need additional information specic to your system please contact your repre-
sentative or a Mold-Masters ofce whose location can be found in the “Global
Support” section.
1.2 Audience
This manual is written for use by skilled persons who are familiar with Hot
Runner Controllers and their terminology.
1.3 Required User Skills
Operators should be familiar with plastic injection molding machines and the
controls of such equipment.
Maintenance persons should have sufcient understanding of electrical safety
to appreciate the dangers of 3-phase supplies. They should know how to take
appropriate measures to avoid any danger from electrical supplies.
BEFORE YOU OPERATE THE CONTROLLER
We recommend that you read the manual fully before connecting up
or using the controller.
We recommend that you run a Self Diagnostic routine on page 7-8
to check that all zones are correctly sequenced and that there is no
cross-wiring between zones or between heater outputs and thermo-
couple inputs.
1.4 Release Details
Document Id Release Date Version
M2K_UM_EN_V3_3 01 October 2014 3
Our policy is one of continuous improvement and we reserve the right to alter
product specications at any time without giving notice.
Section 1 - Introduction
To Next Page
Loading...
