Mold-Masters M2 - Section 5 - SetUp

SETUP
© 2014 Mold-Masters (2007) Limited. All Rights Reserved.
Revised 1 Oct, 2014
5-1
www.moldmasters.com
Section 5 - SetUp
New Touch Screen consoles and controllers are provisionally cong-
ured at the factory and you may not need this section for a new sys-
tem.
However, if you need to match a Touch Screen console to a new tool
or environment then you should use this section of the manual and
work through the four main stages which are summarized in section
5.1 and then described in detail through the rest of the Set Up chapter.
What is included in this section
How to create a rst tool
How to congure the control cards
Setting the tool parameters (on the Setup page such as Standby ,
Boost, Alarm Levels, etc.)
Setting the global parameters ( cong vales on the Setup page - Input
Signal, Startup Mode, Console Language, etc.)
Setting the operating parameters (zone temperatures etc. that are set
on the main page)
Saving all to a tool bank slot
Setting other Utility page functions (such as Passwords, Printing, etc.)