MUTOH Kona - Actions 2;2; Copies

User’s Guide Kona cutting plotter
Operation panel
122 AP-75380 - Revision 1.2
4.2.7 Actions 2/2
Copies
In case multiple outputs of a specific design are needed, use the copies function. This
function will replot the last set of data, which was sent to the cutting plotter. That is, all data
that was sent since the last INITIALISATION command (“IN”).
Set the number of copies as follows:
Step 1: Press the following buttons in order:
 Actions
 next page
 Copies
Step 2: Set the number of copies and confirm with .
Note
 Be aware that you need to set the number of copies before starting any cut
operations.