MUTOH Kona - Contourcutting Errors and Warnings (ID 6201-6271)

168 AP-75380 - Revision 1.2
User’s Guide Kona cutting plotter
Troubleshooting
9.2.3 Contourcutting errors and warnings (ID 6201-6271)
When a specific contour cutting warning or error occurs, an error number will be displayed and a cross will be cut in the lower right corner. All codes
are unique and the cross has a predefined angle and size to know of which nature the error is.
Pre-defined crosses Single frame calibration points Multi frame calibration points
1. Print distortion - Bad rectangle
2. Media shift detected
3. Print distortion - Stretch
4. Possible data clipped
5. Thickness problem
1
3
5
4
2
P1
P2P3
P4
P5P8
P6P7
P1
P2P3
P4
P5P8
P6P7
P11P12
P9P10
P11P12
P9P10
1st segment
middle segments
last segment