MUTOH Kona - Language

User’s Guide Kona cutting plotter
Operation panel
AP-75380 - Revision 1.2 97
4
Color
When performing a manual EPOS color calibration, it is not longer necessary that the
machine performs an automatic color detection. Therefore, you can switch this setting off.
Change the EPOS color setting as follows:
 Settings
 2x next page
 Epos
 Color
 Switch the setting to ON or OFF and confirm by pressing
Language
Set the desired language as follows:
Step 1: Press the following buttons in order:
 Settings
 2x next page
 Language
Step 2: Choose between the different available languages and confirm with
Note
 When performing a new automatic EPOS calibration, the setting is switched
ON.