User’s Guide Kona cutting plotter
Product overview
18 AP-75380 - Revision 1.2
2.3 Part names and functions
N° Description Extended description
1 Pressure rollers To push the media against the grit rollers
2 Media guide
A guiding platform with vacuum fans to transport
the media as flat as possible during cutting
3 Cutting mat
Provides a reliable cutting surface and minimizes
damage to the knife tip
4 Grit rollers
Rollers with a granular surface to move the media
front and backwards
5 Control panel touch screen To make various settings before and during cutting
6 Cutting head
Assembly of cutting knife, sheet-off knife and EPOS
sensor
7 USB inlet To connect the USB cable
8 Power inlet and power switch To connect the power cable and power on the unit
9 Roll conveyor
To support and roll-off the vinyl
(Optional on Kona 760)
10 Stand and wheels
To move the cutter easily
(Optional on Kona 760)
11 Media bag
To collect the media when sheeting off
(Optional on Kona 760)
12 Roll-off system
To roll-off pre printed vinyl
(Optional on Kona 760)
13 Pressure roller lever To lower and raise the pressure rollers
To Next Page
Loading...
