153 AP-75380 - Revision 1.2
User’s Guide Kona cutting plotter
Troubleshooting
Chapter 9 Troubleshooting
Day-to-day use issues . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 155
Warning messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 155
Calibration warning. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 155
Media loaded warning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 156
EPOS warning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 157
Pressure roller positioning warning . . . . . . . . . . . . . . . . . . . . . . . . . . . . 158
Beeping codes: My Kona is making a beeping sound once in a while. . . . . . 161
The USB connection disappears. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 161
The power ON, but the cutter does not operate. . . . . . . . . . . . . . . . . . . . . . . 162
Media is loaded, but the cutter does not operate. . . . . . . . . . . . . . . . . . . . . . 162
Data is being sent from the computer, but the cutter does not react. . . . . . . 162
Data is sent from the computer but errors occur on the cutter’s side. . . . . . 162
Some parts of the design are not well cut. . . . . . . . . . . . . . . . . . . . . . . . . . . 163
The output is 2,5 x too large or 2,5 x too small . . . . . . . . . . . . . . . . . . . . . . . 163
To Next Page
Loading...
