MUTOH Kona - Cut through - Trim Poster

User’s Guide Kona cutting plotter
Operation panel
112 AP-75380 - Revision 1.2
Cut Through - Trim Poster
After printing some posters, it is possible to use the Kona to trim the posters afterwards. Do
this as follows:
Step 1: Load the poster in the cutter.
Step 2: Install a knife at through cut depth.
Refer to Cut through depth on page43
Step 3: Make your personal settings regarding the cut through feature.
 Velocity
 Force
 Tool up distance
 Tool down distance
Refer to Cut through on page102
for all details on how to change the
parameters.
Step 4: Press the following buttons in order:
 Actions
 Cut Through
 Trim poster
Step 5: Set the approximate length and width of the poster.
Step 6: Press the play key.