User’s Guide Kona cutting plotter
Basics
AP-75380 - Revision 1.2 55
3
3.6.4 Loading a roll of vinyl using the media support rollers
Configuration to start from
The pressure rollers are raised.
The media support rollers are installed correctly.
t
The rear media collection bag is open and empty.
The front media collection bag is open (when the cutting job is smaller than 4m).
The front media collection bag closed (when the cutting job is larger than 4m).
Note
The media support rollers are not standard on a Kona 760. This procedure is
only possible when you have this option installed.
Note
Make sure the anti static brushes are installed on the support system. This to
remove all static electricity.
To Next Page
Loading...
