MUTOH Kona - Protocol

User’s Guide Kona cutting plotter
Operation panel
98 AP-75380 - Revision 1.2
Protocol
This menu incorporates Emulation and VS/ZF/AS.
Step 1: To set these parameters press the following buttons in order:
Emulation
 Settings
 2x next page
 Protocol
 Emulation
VS/ZF/AS
 VS/ZF/AS
 Choose between accept and ignore and confirm with
Several cutting software packages enable the user to send speed, force and acceleration
commands to the cutter. The cutter can be set up to accept or ignore these commands.
Note
 When VS and ZF commands are sent and accepted, they will override the
speed, force and acceleration settings the user may have set from the cutter
operation panel. When the VS and ZF commands are ignored, the cutter will
always use the settings, which are set-up from the cutter operation panel.