MUTOH Kona - Knife Types

User’s Guide Kona cutting plotter
Finetuning your cutter
124 AP-75380 - Revision 1.2
5.1 Knife types
There are several knife types available, each of them meant for specific cutting media.
Cutting blade 1
Standard type
Cutting blade 2
Used for thick
media e.g.
Sandblast
Cutting blade 3
Used for thin media
e.g. Film
Top angle (a)
45° (red cap) 30° (yellow cap) 60° (blue cap)
Typical offset 0.50 mm 0.50 mm 0.50 mm
Default speed 60 cm/s (20 inch/s) 60 cm/s (20 inch/s) 60 cm/s (20 inch/s)
Default force
 Contour cutting
 Through cutting
100 g 100 g 100 g
250 g 250 g 250 g
a