MUTOH Kona - Auto Shuffle; Job Focus

User’s Guide Kona cutting plotter
Operation panel
90 AP-75380 - Revision 1.2
Job focus
A lot of advanced cutting settings will be made in the background without any need of
intervention by the end-user. Select by means of the table below the correct job focus.
Step 1: Press the following buttons in order:
 Settings
 Next page
 Job Focus
Step 2: Choose between accuracy and speed and confirm with
Auto shuffle
After an automatic sheet-off, it is possible to let the cutter shuffle the set load length or to hold
until further action is required.
Refer to Load length on page87
Enable or disable this function as follows:
Step 1: Press the following buttons in order:
 Settings
 Next page
 AutoShuffle
Step 2: Choose between ON and OFF and confirm with
Job Focus Description
Accuracy Give in some speed, but gain quality.
Speed Give in some quality, but gain speed.