MUTOH Kona - Resolution

User’s Guide Kona cutting plotter
Operation panel
AP-75380 - Revision 1.2 99
4
Resolution
Please note that some software packages use the “step per mm” terminology, in which case a
program step of 0.025 mm corresponds with 40 steps per mm and a program step of 0.010
mm with 100 steps per mm.
Contour cutting supports only 0.010 mm program step.
Set the resolution as follows:
Step 1: Press the following buttons in order:
 Settings
 2x next page
 Resolution
Step 2: Choose between 0,010 and 0,025 and confirm with
Note
 If the plot unit is not set correctly, all your cutting jobs will be cut 2.5 times too
large or too small.