MUTOH Kona - Page 167

167 AP-75380 - Revision 1.2
User’s Guide Kona cutting plotter
Troubleshooting
6098 EPOS calibration error Could not calibrate the pen to laser distance
 Make sure that the difference
between white and colour can
be recognized by the EPOS
sensor
Refer to EPOS read on page120
 The media has not been weed
out (when asked on the display)
before the EPOS alignment
measurement
 The laser is broken.
Warning
6099
EPOS measurement is
unstable
There is too much variation between the X and Y calibration
measurements
 Is the media loaded correctly?
Refer to Loading media on
page47
Warning
6100
Bump problem machine
width
The cutter cannot finish the cutter width measurement
routine. This could be caused by a mechanical obstruction.
Remove the media or object
blocking the head from moving and
restart the cutter.
Warning
6105
X measurement problem.
Reload media
The rear media sensor is uncovered during a media
measurement routine
 Is the media loaded correctly?
Refer to Loading media on
page47
Warning
6115
TFT board detection
problem
The flatcable of the touch screen is not connected or broken
Contact an authorized Mutoh
technician
Warning
Error Message Description Solution Category