MUTOH Kona - Page 173

173 AP-75380 - Revision 1.2
User’s Guide Kona cutting plotter
Troubleshooting
6241
Thickness
problem
frame top
All measured points of frame top vary too much from each other! This will
influence the accuracy of the cutting.
You can try to cut the job if you want
to. Perfect quality is not guaranteed.
What to check in case of bad quality:
 Printer settings
 RIP settings
 Design
Refer to Bounding box details on
page134
Warning
6242
Thickness
problem
frame top
Invalid thickness of P5 (right side of frame top). Thickness varies too much from
other top points! This will influence the accuracy of the cutting.
6243
Thickness
problem
frame top
Invalid thickness of P6 (top right of frame top). Thickness varies too much from
other top points! This will influence the accuracy of the cutting.
6244
Thickness
problem
frame top
Invalid thickness of P7 (top left side of frame top). Thickness varies too much from
other top points! This will influence the accuracy of the cutting.
6245
Thickness
problem
frame top
Invalid thickness of P8 (left side of top point). Thickness varies too much from
other top points! This will influence the accuracy of the cutting.
6246
Thickness
problem
frame top
Invalid thickness of P5 and P8. Thickness of these points varies too much from
each other AND varies also from P6 & P7! This will influence the accuracy of the
cutting.
6247
Thickness
problem
frame top
Invalid thickness of P6 and P7. Thickness of these points varies too much from
each other AND varies also from P5 & P8! This will influence the accuracy of the
cutting.
Error Message Description Solution Category