MUTOH Kona - Page 175

175 AP-75380 - Revision 1.2
User’s Guide Kona cutting plotter
Troubleshooting
6261
No valid frame
found
No valid frame found during fast scan routine (after several retries). Make sure all
frame specifications are applied.
To check:
 Frame isn't found within 120 cm.
Media space before frame bottom
is too much.
 Frame bottom doesn't have the
correct specifications (minimum
thickness of 3mm on ALL sides,
thickness too varying, frame
height < 20cm, frame width <
10cm, frame angle < 5°)
Refer to Bounding box details on
page134
Error
6262
No valid frame
found
Only 1 frame point found during diagonal scan.
6263
No valid frame
found
No frame points found during diagonal scan.
6264
No valid frame
found
Thickness of left side of frame invalid
6265
No valid frame
found
Varying thickness
6266
No valid frame
found
Invalid thickness
6267
No valid frame
found
Invalid frame angle
6268
No valid frame
found
Requested X movement for fast scan cannot be executed.
6269
No valid frame
found
Invalid spot type
6271
Media shift
detected
Media displacement detected during cutting. Centre markers of previous segment
are shift more than 2mm.
To check:
 Grits on media?
 Pinches and grits clean?
Refer to Cleaning the grit rolls on
page150
Warning
Error Message Description Solution Category