MUTOH Kona - Page 86

User’s Guide Kona cutting plotter
Operation panel
86 AP-75380 - Revision 1.2
Media measure
method
Media measurement
With front
When lowering the pressure rollers, the cutter determines the left, right
and front side of the media.
Next to this, the cutter feeds the media forward.
 In case the rear sensor does not longer detect media, the cutter
automatically knows sheet media is loaded.
 In case the rear sensor remains covered, the media will be fed
forward the set value of the load length.
Refer to Load length on page87
The origin will be defined from the front of the media.
Without front
When lowering the pressure rollers, the cutter determines the left and
right side of the media.
Next to this, the cutter feeds the media forward.
 In case the rear sensor does not longer detect media, the cutter
automatically knows sheet media is loaded.
 In case the rear sensor keeps covered, the media will be fed forward
the set value of the load length.
Refer to Load length on page87
The cutter will not feed the media back to the beginning of the media.
With front
Uneven media
In case the front / backside of the media is slightly curled, select this
option. Compared to the setting "With Front" the cutter will feed the
media forward, move the head over the media and determine the left,
right and front side of the media. This way the media is kept flat.
Next to this, the cutter feeds the media forward.
 In case the rear sensor does not longer detect media, the cutter
automatically knows sheet media is loaded.
 In case the rear sensor keeps covered, the media will be fed forward
the set value of the load length.
Refer to Load length on page87
The origin will be defined from the front of the media.
Without front
Uneven media
In case the front / backside of the media is slightly curled, select this
option. Compared to the setting "Without Front" the cutter will feed the
media forward, move the head over the media and determine the left
and right side of the media. This way the media is kept flat.
Next to this, the cutter feeds the media forward.
 In case the rear sensor does not longer detect media, the cutter
automatically knows sheet media is loaded.
 In case the rear sensor keeps covered, the media will be fed forward
the set value of the load length.
Refer to Load length on page87
The cutter will not feed the media back to the beginning of the media.