184 eCobra User's Guide 14402-000 Rev. F
9.5 User Connectors
Figure 9-13. IP65 Internal Connectors with Outer Link Cover Removed
Table 9-4. IP65 Internal Connector Description
Item Description
1 6 mm Air Line
2 User Electric
3 4 mm Air Line
4 DeviceNet
5 Spare Air Lines (x2)
User Air Lines
The user air line connectors are fitted with removable plugs at the factory. See Figure 9-12.
The user air line connectors on the outer link are accessible with the cover removed. See Figure
9-13. for locations of the internal connectors.
When routing air lines outside of the robot, any fittings you use must maintain an adequate
seal in the cover to prevent moisture from entering the outer link.
NOTE: Failure to prevent water intrusion through improperly-sealed external fit-
tings could void your warranty.
Robot Solenoid Option
In an IP65 robot, if you are installing the internally-mounted solenoid hand valves (Option Kit
p/n 02853-000), you must use a different air line than described in Installing the Robot Solen-
oid Kit on page 132.
To Next Page
Loading...
