Omron NS Programming Manual

Section 2 NS Series Functions 2-20 Special Functions
2-432
NS Series Programming Manual
2. Right-click to display the menu, and then select Operation to Log Setting.
3. The Operation Log Setting Dialog Box will be displayed.
2.
3.
1.
No. Setting Details
1 Record to Operation Log Select to maintain an operation log for the functional object.
2 Switch Sets the label to be set.
3 Message Sets a message string of up to 32 characters.
4. Click the OK Button.
N
N
N
o
o
o
t
t
t
e
e
e
♦
Messages can be set if the project version is 8.0 or higher.
Communications Address Value Change History
Changes in bit-type communications address status can be recorded. Up to 16 communications ad-
dresses can be set.
Operation for items other than NS-series screens can be recorded by assigning control panel switches
to PLC addresses.
1. Select the communications address (bit) for which to set the operation log from the symbol table.
2. Right-click to display a menu, and then select Operation Log Setting.
3. The Operation Log Setting Dialog Box will be displayed.
2.
3.
1.
No. Setting Details
1 Record to Operation Log Select to maintain an operation log for the functional object.
2 Switch Sets the label to be set.
3 Message Sets a message string of up to 32 characters.
4. Click the OK Button.
N
N
N
o
o
o
t
t
t
e
e
e
♦
The project data version must be version 8.0 or higher to record changes in communications ad-
dresses in the operation log.

Omron NS Specifications

General

Power Supply	24 VDC
Display Size	5.7 to 12.1 inches (depending on the model)
Resolution	320 x 240 to 800 x 600
Touchscreen Type	Resistive
Display Type	TFT LCD
Communication Interfaces	RS-232C, RS-422/485, Ethernet, USB
Memory	Flash memory
Operating Temperature	0 to 50°C (depending on the model)
Storage Temperature	-20°C to 60°C
Protection Rating	IP65 (front panel)
Dimensions	Varies depending on the model
Weight	Varies depending on the model
CPU	Proprietary Omron CPU (performance varies depending on the model)