Section 2 NS Series Functions 2-20 Special Functions
2-485
NS Series Programming Manual
2. Operate the object (created in step 1) on the PT’s screen.
3. The Programming Console function will start.
N
N
N
o
o
o
t
t
t
e
e
e
♦
The data storage format (binary or BCD) of the values set in $SW0 is determined by the
BCD/Binary setting in the System Memory List, which can be displayed by selecting PT - Sys-
tem Setting, clicking the Initial Tab, and clicking the System Memory List Button.
Exiting the Programming Console Function
To close the Programming Console function, press the Exit Button. When the Programming Console
function is closed in earlier-model PTs, the initial screen will be displayed. When the function is closed
in a PT with the built-in Programming Console function, the PT will revert to the user screen that was
displayed when the Programming Console function started. If the Programming Console function was
started from the system menu, the PT will revert to the user screen displayed before the system menu.
N
N
N
o
o
o
t
t
t
e
e
e
♦
The NS-series PT will revert to the user screen that was displayed before the Programming
Console function started only if the PT has system version Ver. 6.6 or higher and Program-
ming Console function Ver. 2.10 or higher.
If the NS-series PT has a system version lower than Ver. 6.6 or a Programming Console func-
tion version lower than Ver. 2.10, the PT will be reset when the Programming Console function
is closed. When the PT restarts, the initial screen is displayed.
To Next Page
Loading...
Need help?
General
