Section 5 Troubleshooting and Maintenance 5-2 Error Messages
5-11
NS Series Programming Manual
No. Message Cause Possible countermeasure
23 WARNING No. 23: Screen data file(s) is
not correct: Touch the screen to continue
and transfer screen data again.
The screen data in the
PT is damaged. (The PT
power supply was turned
OFF while screen data
was being transferred, or
a cable was discon-
nected.)
Touch the PT’s touch panel, and
after connecting is displayed at
the bottom right of the screen, or
after the message “No project
data is registered. Press OK but-
ton and download project data.” is
displayed, reattempt screen
transfer.
To Next Page
Loading...
