Omron SYSDRIVE 3G3FV - Page 322

7-34
Para
meter
No.
PageControl mode Chan-
ges
during
opera-
tion
Default
setting
Setting
range
DescriptionNamePara
meter
No.
Page
Flux
vector
Open
loop
vector
V/f
with
PG
V/f
control
Chan-
ges
during
opera-
tion
Default
setting
Setting
range
Description
Display
name
F8-01
E-15
operation
selection
Selects inverter operation to
perform when a
communications error occurs at
the SYSMAC BUS (Wired) I/F
Card.
0 to 3 1 NO B B B B 6-74
E-15 Det
Sel
Card
.
0:
Decelerate to stop.
1: Coast to stop.
2: Emergency stop.
3: Continue operation.
F9-01
Commu-
nications
external
fault input:
input type
Selects the type of input used
for the communications external
fault input from communications
(CompoBus/D Communications
Card.)
0 Nll i
0, 1 0 NO B B B B 6-74
EFO
Selection
Ca d )
0: Normally open input
1: Normally closed input
F9-02
Commu-
nications
external
fault input:
detection
method
Selects the detection method for
used for the communications
external fault input from
communications (CompoBus/D
Communications Card.)
0: Always detect.
1 Dt td i ti
0, 1 0 NO B B B B 6-74
EFO
Detection
y
1: Detect during operation.
F9-03
Commu-
nications
external
fault input:
Operation
Selects the inverter operation to
perform when there is an
communications external fault
input from communications
(CompoBus/D Communications
Card.)
0:
Decelerate to stop in the
time set in C1-02.
(Protective operation)
1: Coast to sto
p
0 to 3 1 NO B B B B 6-75
EFO Fault
Action
1: Coast to stop.
(Protective operation)
2: Emergency stop in the time
set in C1-09.
(Protective operation)
3: Continue operation.
(Alarm)
F9-04
Not used.
--- 0 to
60000
0 NO B B B B ---
90
Trace
Sample T im
0o
60000
0
O
F9-05
Torque
reference/
torque limit
selection
from
communica
tions
This setting enables or disables
torque reference and torque
limit values input from
communications (CompoBus/D
Communications Card.)
Note: Always set to “disable”
when using a CompoBus/
D Communications Card.
0: Disable torque reference/
tliitf
0, 1 1 NO X X X B 6-75
TorqueRef/
Lmt Sel
q
torque limit from
communications.
1:
Enable torque reference/
torque limit from
communications.
Parameter Lists Chapter 7